Strip Ceiling OM3: Malaysia B2B Marketplace, MDEX - Malaysia Digital Enterprise Exchange

Strip Ceiling OM3

Cross-sectional Profile

OM3 panels are fixed onto carrier Metal Bar (MB3, MB3-85S or MB3-135S). The panels are to be installed from right to left or vice-versa. The MB3 carrier has profiled flanges which are designed to fit the shape of the OM3 panels. Initially, the leg of the OM3 panel is slotted into the carrier MB3 and then light pressure is applied on the panel to ensure that the OM3 panel is clipped on firmly to the carrier

100mm/150mm

85Smm/150mm

MATERIAL SPECIFICATION / SELECTION GUIDE

STRIP CEILING-OM3

DESCRIPTION

Profile and Material Available

· OM3A – Aluminium c/w Polyester Paint Finish

· OM3B – Clean COLORBOND^® steel / PRIMAMAJU^™steel / ELEMENTS^™ steel

Material Thickness

· Aluminium c/w Polyester Paint Finish

· Clean COLORBOND^® steel / PRIMAMAJU^™steel / ELEMENTS^™ steel

· 0.50mm TCT

· 0.38mm / 0.48mm TCT

Panel Effective Width & Deep

· OM3 A/B 100

· OM3 A/B 150

· OM3 A/B 85S

· OM3 A/B 135S

· 100mm width x 15mm deep

· 150mm width x 15mm deep

· 85mm width x 15mm deep

· 135mm with x 15mm deep

Carrier

· OM3 A/B 100 / 150

· OM3 A/B 85S / 135S

· MB3

· MB3 – 85S / 135S

Length

Made to order with a minimum length of 2 meter.

Recommended optimum length of 6 meter,

Method of Installation

Clip-on

Colours Available

Silver / Gold / White

Other colours available upon request subject to stock available and time delivery

Installation Method

OM3 Panels are fixed onto the carrier Metal Bar (MB3, MB3-85S or MB3-135S). The panels are installed right to left or vice-versa. The MB3 carrier has profile flanges corresponding to the shape of the OM3 panels. The leg of the OM3 is first slotted into the carrier and then light pressure is applied on the panel to ensure that the OM3 is engaged firmly to the carrier.

OM3 100mm/150mm

OM3 85Smm/135mm

* Max. 600mm c/c for external. Max. 900mm c/c for internal

Spacing shall subject to actual site condition.

Important Note: Flat metal surfaces will display waviness commonly referred to as oil canning. This caused by steel mill tolerances and is a characteristic, not a defect, of panels manufactured from light gauge metal. Oil canning will not be accepted as a cause for rejection.